Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 36)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
• An error message: "The error occurred with 'Set' operation. Error: gen Error"
• Port Speed and Mode parameter value changing to '100Mbps half-duplex'
Note - The current firmware version does not allow the Port Bridge ID parameter to be
configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Note - When a port is set to 'auto sense' and is connected to a half duplex port on another
device, its corresponding Duplex LED on the device image turns green instead of orange.
Note - The current firmware version does not allow the Port Back Pressure parameter to
be configured. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: time out occurred."
Note - The Port Transmit Pacing Configuration parameter is not applicable to the AT-
8124XL (V2).
Note - The current firmware version does not allow the Port VLAN Tag Priority and the
Port QoS Priority parameters to be configured. Attempting to configure these parameters
will result in the error message: "The error occurred with 'Set' operation. Error: bad
value."
Note - Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value.".
Spanning Tree Info
Displays the port's spanning tree parameters.
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring state,
source, and destination.
IGMP Snooping
Displays the current state of IGMP Snooping and allows reconfiguration.
AT-8124XL (V2)
PN 613-50665-00 Rev B Page 36 of 277