Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 265)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - AT-RG634A: Valid MIB Set values for the Interface parameter are in the
range [1-75] inclusive. But the current firmware version allows the parameter to
be set to more than 75 characters.
Note - AT-RG634A: Valid MIB Set values for the NAT IP Address parameter are
in the range [0-255] inclusive. Attempting to set this parameter to a value outside
the valid range will result in the error message: "No access error."
Note - AT-RG634A: Values displayed on the Protocol Info MIB variable window
may not be consistent with what is set on the device.
Note - AT-RG634A: Valid MIB Set values for the Interface parameter is in the
range [1-75] inclusive. Attempting to set this parameter to a value outside the
valid range will not result to an error message but will cause the device to restart.
Call Agent Info
Displays a list of all call agents available.
Note - AT-RG634A: It may take a while before the correct number of call agents
are displayed in Device Manager.
Port Menu
From the Port menu, you can view and edit MIB information about the ethernet and voice ports.
Utilization
Displays the port's utilization information.
Interface Info
Ethernet
Displays ethernet port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Note - Valid MIB Set values for the Port Speed and Mode parameter of the 100Base-FX
WAN ports should only be '100Mbps full-duplex', '100Mbps half-duplex', and 'auto
sense'. However, the current firmware version allows it to be set to '10Mbps full-duplex'
or '10Mbps half-duplex' as well.
Note - Under the Additional Info sub-menu option, if the Port Speed and Mode parameter
is currently set to '100Mbps full-duplex', it cannot be changed to '100Mbps half-duplex'
directly. You will have to set it to some other speed and mode first. This is true for all
LAN and WAN ports.
Note - The Port Flow Control parameter has a fixed value of 'flow' and cannot be
modified.
PN 613-50665-00 Rev B Page 265 of 277