Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 262)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
If GSPAN is loaded on the device, the same behavior may occur when the Comment or
Password parameters are set to a string that is more than 65 characters long and more than
84 characters, respectively,
Note - AT-RG656BD: Valid MIB Set values for the Comment parameter are in the range
[0-89] inclusive. Attempting to set this parameter to a value outside the valid range will
cause the device to restart and will eventually result in the error message: "The error
occurred with 'Set' operation. Error: Time out occurred."
Note - AT-RG656BD: Valid MIB Set values for the Password parameter are in the range
[0-75] inclusive. Attempting to set this parameter to a value outside the valid range will
cause the device to restart and will eventually result in the error message: "The error
occurred with 'Set' operation. Error: Time out occurred."
Battery Backup Info
Displays power backup status such as the Backup Battery Status and Backup Primary
Status
Reset
Resets the residential gateway.
CPE Config Save
Saves the configuration made in the residential gateway.
Note - AT-RG634A: The CPE Config Save option does not save the changes made to the
configuration file.
Telnet
Starts a Telnet connection to the residential gateway.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as forwarding database,
aging time info and Quality of Service (QoS) info.
Forwarding Database
Displays the Forwarding Database table.
Aging Time Info
Displays information about the aging time status, mode, and value.
Note - AT-RG613xx : The Aging Time Value parameter has a fixed value of 0 and cannot
be modified.
Note - AT-RG634A: Valid MIB Set values for the Aging Time Value parameter are in
the range [0-2147483647] inclusive. Attempting to set this parameter to any value will
not result in an error, but the new value will not be applied.
PN 613-50665-00 Rev B Page 262 of 277