Allied Telesis AlliedView-UM 2.0 - Manual (Page 94)

A. Creating a Help File Update Profile
Software Selection
1. Help Filename - Specify the Help file to use.
2. Upload Options - Choose one of the following options:
• Upload - Uploads the Help file only.
• Upload and set - Uploads and sets the Help file.
3. File Deletion Options
• Delete old help files if memory space is insufficient checkbox - If the devices
to be upgraded have limited memory space (e.g. routers), there might be a
need to delete the existing Help files in order to accommodate the new Help
file. If a Help file cannot be downloaded due to space limitations and this
option is checked, AlliedView-UM will delete any Help files residing in the
device except for the currently set Help file. If unchecked, and there is not
enough space to accommodate the new Help file, AlliedView-UM will fail the
operation.
• Delete currently used help file if memory space is insufficient checkbox -
This option will only be enabled if the above option is checked. Otherwise, it
will be grayed out. When this option is checked, AlliedView-UM will also
delete the currently set Help file if there is still insufficient space in the device
after deleting the other Help files.
Upload Parameters
1. Server - This is the address for the server that contains the Help file. If the server is
a TFTP server, the server address should be specified as an IP address. If the server
is an HTTP server, the server address should be specified as a URL.
2. Destination - This sets the location where the new Help file will be stored. This can
be set to FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to
HTTP or TFTP.
AlliedView™-UM 2.0 USER’S GUIDE Page 94 of 128