Allied Telesis AlliedView-UM 2.0 - Manual (Page 70)

Upload Parameters
1. Server - This is the address for the server that contains the Patch file. If the server is
a TFTP server, the server address should be specified as an IP address. If the server
is an HTTP server, the server address should be specified as a URL.
2. Destination - This sets the location where the new Patch file will be stored. This can
be set to FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to
HTTP or TFTP.
Device Selection
Before device selection can be performed, a patch file must be specified. After specifying a
patch file, the Available Devices list will be populated with the IP addresses of the devices to
which the specified patch file can be applied to.
Except for the above mentioned process, device selection is similar to that of the Release
Upgrade Operation pane.
B. Saving a Patch Upgrade Profile
1. Click on the button.
AlliedView™-UM 2.0 USER’S GUIDE Page 70 of 128