Allied Telesis AlliedView-UM 2.0 - Manual (Page 56)

Upload Parameters
1. Server – This is the address for the server that contains the release file. If the server
is a TFTP server, the server address should be specified as an IP address. If the
server is an HTTP server, the server address should be specified as URL
2. Destination – this sets the location where the new release file will be stored. This
can be set to FLASH or NVS.
3. Protocol – This specifies the protocol that the server supports. This can be set to
HTTP of TFTP.
Software Selection and Upload Parametes (non-AlliedWare)
1. Release Filename – Specify the software file to be used.
2. Boot File – Specify the boot file to be used. This is only applicable to the AT-8000S
and AT-8000GS Family.
1. TFTP Server – This is the IP address of the TFTP server that contains the release file.
2. Destination Filename – This is a read-only field displays the name under which the
software release file is to be stored on the switch.
Device Selection
For devices that use AlliedWare™ management software, a license list file must be specified
before device selection can be performed. After selecting a license list file, the serial
numbers contained within will be checked against the serial numbers of the currently loaded
devices. The IP Address of each matching pair will be added to the Available Devices list.
AlliedView™-UM 2.0 USER’S GUIDE Page 56 of 128