Allied Telesis AlliedView-UM 2.0 - Manual (Page 63)

A. Creating an Interim/ Maintenance Release Upgrade Profile
Software Selection
1. Interim/Maintenance Release Filename - Specify the interim/maintenance release file
to use.
2. Upload Options - Choose one of the following options:
• Upload - Uploads the interim/maintenance release file only.
• Upload and enable - Uploads and enables the interim/maintenance release file
only.
• Upload and set as temporary - Uploads, enables, and sets the
interim/maintenance release file as the temporary release file.
• Upload and set as preferred - Uploads, enables and sets the
interim/maintenance release file as the preferred release file.
3. File Deletion Options
• Delete old release files if memory space is insufficient checkbox - If the
devices to be upgraded have limited memory space (e.g. routers), there
might be a need to delete the existing release files in order to accommodate
the new release file. If a release file cannot be downloaded due to space
limitations and this option is checked, AlliedView-UM will delete any release
files residing in the device except for the currently installed release. If
unchecked, and there is not enough space to accommodate the new release
file, AlliedView-UM will fail the operation.
• Delete currently installed release file if memory space is insufficient
checkbox – This option will only be enabled if the above option is checked.
Otherwise, it will be grayed out. When this option is checked, AlliedView-
UM will also delete the currently installed release file if there is still
insufficient space in the device after deleting the other release files.
4. Reboot device after updating checkbox - If "Upload and set as temporary" or
"Upload and set as preferred" is chosen as the Upload Option, this checkbox
will be enabled. When checked, AlliedView-UM will reboot the device after a
performing the software upgrade.
AlliedView™-UM 2.0 USER’S GUIDE Page 63 of 128