Allied Telesis AlliedView-UM 2.0 - Manual (Page 76)

NOTE:
For the AT-8000S and AT-8000GS Family,
• Choosing “Upload” means that the contents of the specified configuration file will be added to those in the
running configuration of the device, thus, the loaded configuration will take effect as soon as the operation ends.
However, the loaded configuration will not be copied to the startup configuration which might be erased after
rebooting the device.
• Choosing “Upload and Set” means that the contents of the specified configuration file will replace the startup
configuration of the device, thus, the loaded configuration will take effect after rebooting the device.
• The “Delete old configuration files if memory space is insufficient” and “Delete currently used configuration file if
memory space is insufficient” options are disregarded by the application.
Upload Parameters
1. Server - This is the address for the server that contains the Configuration file.
If the server is a TFTP server, the server address should be specified as an IP
address. If the server is an HTTP server, the server address should be specified
as a URL.
2. Destination - This sets the location where the new Configuration file will be stored.
This can be set to FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to
HTTP or TFTP.
NOTE:
The Destination field is not applicable to devices that use AlliedWare™ and non-AlliedWare Plus™ management software
and will be ignored during the Configuration File Update operation.
Since devices that use non-AlliedWare™ and non-AlliedWare Plus™ management software only support TFTP, the
Protocol field will also be ignored but will internally be set to "TFTP" during the Configuration File Update operation.
Device Selection
The Available Devices list will be initially populated with the IP addresses of the devices
which have a Configuration file specified in its device definition.
Except for the above mentioned process, device selection is similar to that of the Release
Upgrade Operation pane.
AlliedView™-UM 2.0 USER’S GUIDE Page 76 of 128