Allied Telesis AlliedView-UM 2.0 - Manual (Page 69)

A. Creating a Patch Upgrade Profile
Software Selection
1. Patch Filename - Specify the Patch file to use.
2. Upload Options - Choose one of the following options:
• Upload - Uploads the Patch file only.
• Upload and set as temporary - Uploads, enables, and sets the Patch file as the
temporary Patch file.
• Upload and set as preferred - Uploads, enables and sets the Patch file as the
preferred Patch file.
3. File Deletion Options
• Delete old patch files if memory space is insufficient checkbox - If the devices
to be upgraded have limited memory space (e.g. routers), there might be a
need to delete the existing patch files in order to accommodate the new
patch file. If a patch file cannot be downloaded due to space limitations and
this option is checked, AlliedView-UM will delete any patch files residing in
the device except for the currently installed patch. If unchecked, and there is
not enough space to accommodate the new patch file, AlliedView-UM will fail
the operation.
• Delete currently installed patch file if memory space is insufficient checkbox
– This option will only be enabled if the above option is checked. Otherwise,
it will be grayed out. When this option is checked, AlliedView-UM will also
delete the currently installed patch file if there is still insufficient space in the
device after deleting the other patch files.
4. Reboot device after updating checkbox - If "Upload and set as temporary" or
"Upload and set as preferred" is chosen for the Upload Option, this
checkbox will be enabled. When checked, AlliedView-UM will reboot the
device after a performing the software upgrade.
AlliedView™-UM 2.0 USER’S GUIDE Page 69 of 128