Allied Telesis AlliedView-UM 2.0 - Manual (Page 64)

Upload Parameters
1. Server - This is the address for the server that contains the interim/maintenance
release file. If the server is a TFTP server, the server address should be specified as
an IP address. If the server is an HTTP server, the server address should be specified
as a URL.
2. Destination - This sets the location where the new interim/maintenance release file
will be stored. This can be set to FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to
HTTP or TFTP.
Device Selection
Before device selection can be performed, an Interim/Maintenance Release File must be
specified. After selecting an Interim/Maintenance Release File, the Available Devices list will
be populated with the IP addresses of the devices to which the specified interim release file
can be applied to.
Except for the above mentioned process, device selection is similar to that of the Release
Upgrade Operation pane.
B. Saving an Interim/Maintenance Release Upgrade Profile
1. Click on the button.
AlliedView™-UM 2.0 USER’S GUIDE Page 64 of 128