Allied Telesis AT-8100 Series - Manual (Page 198)

Chapter 17: RADIUS and TACACS+ Clients
198
authentication is attempted using the password specified using
the ENABLE PASSWORD command in the CLI.
Disabled: The TACACS+ servers do not use its enable
password. Authentication is attempted using the password
specified using the ENABLE PASSWORD command in the
CLI.
 AAA Accounting— Select a TACACS+ accounting setting.
Choose from the following:
Start-Stop: A start accounting message is sent at the
beginning of a session, and a stop accounting message is sent
at the end of the session.
Stop-Only: A stop accounting message is sent at the end of
the session.
None: Sending accounting messages is disabled.
5. Click Apply.
The Active Authentication Server field shown on the upper middle of
the page indicates “TACACS+.”
6. Click SAVE to save your changes to the startup configuration file.
Adding a
TACACS+
Server
To add a TACACS+ server, do the following:
1. Click Add at the bottom of the page.
The TACACS+ Server Add page is displayed. See Figure 74.
Figure 74. TACACS+ Server Add Page