5 multiplexer wiring, 1 avw200 controlling the multiplexer, Multiplexer wiring – Campbell Scientific AVW200-series Vibrating Wire Interfaces User Manual
Page 30: Avw200 controlling the multiplexer, 3. datalogger to spread spectrum radio connections

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules
Wireless communication requires the appropriate spread spectrum radio to be
connected to the datalogger (see TABLE 4-3). DevConfig is used to configure
the AVW206, AVW211, or AVW216 for RF communications (Section 5.1,
Connecting to DevConfig, and Section 5.2.1, Communications).
TABLE 4-3. Datalogger to Spread Spectrum Radio Connections
Vibrating Wire
Interface Model
Required Spread
Spectrum Radio
Model
Cable used for
datalogger to
radio connection
Radio Port for
Cable Attachment
Datalogger Port
for Cable
Attachment
AVW206
RF401
SC12
CS I/O
CS I/O
AVW211
RF411
SC12
CS I/O
CS I/O
AVW216
RF416
SC12
CS I/O
CS I/O
(1) The AVW206, AVW211, and AVW216 are not compatible
with the RF450, RF400, RF410, and RF415 spread spectrum
radios.
(2) For communication between the vibrating wire interface and
spread spectrum radio to be successful, the radio’s Protocol must
be set to PakBus Aware or PakBus Node.
Read more! Description of our antenna options is provided in Appendix
C. More information about using spread spectrum radios is provided in
the RF401/RF411/RF416 Spread Spectrum Data Radio/Modem manual.
4.5 Multiplexer Wiring
Wire the sensors to the multiplexer according to the multiplexer manual. Other
multiplexer wiring depends on whether the AVW200 will control the
multiplexer or the datalogger will control the multiplexer.
4.5.1 AVW200 Controlling the Multiplexer
For most applications, it is desirable to have the AVW200 control the
multiplexer. A CABLE4CBL or MUXSIGNAL cable connects to the
multiplexer’s COM terminals, and another CABLE4CBL cable or the
MUXPOWER cable connects to the multiplexer’s CLK and RESET terminals
When two multiplexers are connected to the AVW200, they share
the CLK and RESET lines. Because of this, while one multiplexer
is making measurements, the other multiplexer will advance its
channels but without making any measurements.
NOTES
NOTE
22