MagTek QwickPAY - Manual (Page 32)

29 www.qwickpay.com
C. Managing my account in the Virtual Terminal
QwickPAY offers a variety of MagneSafe card readers that can be used with the Virtual Terminal. Using the included Micro-USB
cable (Micro-B), connect the uDynamo, Dynamag, BulleT, Flash, or IPAD to a host USB port on your computer or mobile phone/
tablet. The uDynamo, Dynamag, BulleT, Flash and IPAD allow you to swipe card data into the virtual terminal. The IPAD also
allows card data to be manually entered into its secure keypad where the data can be encrypted and secured prior to the card
data entering the Virtual Terminal. This may allow for greater reduced PCI scope.
It is required to do the following to drive the USB HID MagneSafe Devices:
Cookies must be enabled in the browser’s settings; MUST launch the browser the first time as “Run As Administrator” to successfully
download and install the MagTek Java Applet(s); Java 7 or newer must be installed and running. (To determine the version of Java
that you have, please go to http://www.java.com/en/ and click the link “Do I Have Java?”)
Flash
mobile storage of data
USB HIB connection
Dynamag
USB HID connection
Connect
Connecting via USB HID
4
C. Virtual terminal
uDynamo
USB HID connection
Connecting BulleT
(USB HID or Bluetooth keyboard connection)
Charging and Power
It takes approximately 2.5 hours to fully charge the battery and it will stay charged for approximately 100 card swipes. The
LED will slowly blink amber while the battery is charging and then turn solid amber when the battery is fully charged (for best
results, allow the battery to fully charge).
BulleT
USB HID or
Bluetooth keyboard
connection
USB HID connection for transactions
Attach the Micro-USB cable to a USB port to process transactions using USB HID connection.
Bluetooth keyboard (KB) connection
1. Go to Control Panel for Windows or System Preferences for a Mac
2. Select Bluetooth Settings
3. Add a Bluetooth Device
4. Turn on the BulleT KB reader; a green light will flash when the device is trying to connect
5. Select Scan for devices
6. Select the MagTek Keyboard device when it appears on the screen
7. Computers and smart phones/tablets should automatically pair with the reader
8. At this point the BulleT KB is paired and ready for use
IPAD® DynaPro DynaPro
Mini
PIN entry/SCRA devices with USB HID connection