MagTek QwickPAY - Manual (Page 17)

14 www.qwickpay.com
B. Managing my account for mobile devices.
4
b. Pair and Connect BulleT via Bluetooth
i. Android
The MagTek BulleT secure card reader authenticator uses Bluetooth technology to connect and communicate with your
Android device. The BulleT uses an internal, rechargeable battery.
Made for
OS 2.3.3 or higher
USB HID connection
Insert the Micro-B end of the cable into Micro-B port on the bottom of the reader and the Standard-A
connector into a USB port on the PC/Mac. USB connection will automatically detect your device.
Charge
Attach the USB cable. It takes approximately 2.5 hours to fully charge the battery and it will stay charged for
approximately 100 card swipes. The LED will slowly blink amber while the battery is charging and then turn
solid amber when the battery is fully charged (for best results, allow the battery to fully charge).
The power switch is located on the front of the reader.
Press to turn ON (default is 120 seconds).
Hold 1 second to extend ON.
Hold 3 seconds to turn OFF.
Power Switch LED Indicator (Charging)
Pairing and Connecting
1. On your Android device pull up APPLICATIONS or MENU (depending on your
Android device) and select SETTINGS.
2. Select WIRELESS AND NETWORK.
3. Select BLUETOOTH SETTINGS.
4. Turn on the BulleT reader; a green light will flash when the device is trying to
connect.
5. On your Android device select SCAN FOR DEVICES.
6. Select the MAGTEK DEVICE when it appears on the screen.
7. The screen will prompt you for a PIN (the default is 1234).
8. At this point the device is
PAIRED BUT NOT CONNECTED to QwickPAY.
9. Go to the QwickPAY Application on your device.
10. In the App, the top red bar shows the device is not connected.
11. Press the ‘Android MENU’ button on your Android device and choose CONNECT.
12. Connect to the desired MAGTEK BLUETOOTH device.
13. The top green bar shows the device is now connected.
14. The device is now ready to use.
LED Color LED Condition USB Connection Meaning
Off Off n/a No power
Green Steady On -- Ready to read a card - after power button pushed
Green Rapid Flashing No Searching for Bluetooth connection
Green Slow Blinking -- Authentication has been established -
ready to read a card
Green On 2 seconds -- Good Read
Amber Steady On Yes Battery fully charged
Amber Short Flash No After power button is pushed
Amber Slow Blinking Yes Battery charging
Red Steady On -- Authentication failed
Red Short Flash -- Following amber after power button is pushed
Red Rapid Flashing Yes Battery voltage too low to operate normally
Red On 2 seconds -- Bad card swipe
LED Indicators
11