Acer ALTOS 1100E - Manual (Page 157)

Index 3
IDE secondary channel master, 3-6
IDE secondary channel slave, 3-6
Initialize SCSI before IDE, 3-19
Installing 32 bit PCI cards, 2-22
Installing a DIMM, 2-20
Installing a Pentium III processor, 2-
15
Installing an AGP card, 2-23
Installing an expansion board, 1-24
Installing and removing a heatsink,
2-13
Installing expansion cards, 2-22
32 bit PCI cards, installing, 2-22
AGP card, installing, 2-23
Installing drives, 1-7
3.5-inch drive, 1-7
5.25-inch drives, 1-9
Installing hot-swap cages, 1-11
BP-L3, installing, 1-11
BP-L3 hard disk drive tray,
installing and removing, 1-15
BP-L5, installing, 1-16
BP-L5 hard disk drive tray,
installing and removing, 1-19
Comparison table, BP-L3 and BP-
L5, 1-11
Installing components 2-10
ESD precautions, 2-11
Instructions, post-installation, 2-12
Instructions, pre-installation, 2-11
Installing the RDM module, 2-25
Installing the termination board, 2-18
Internal cache, 3-5, 3-33
Internal structure, 1-4
J
Jumper and connector locations, 2-5
Jumper settings, 2-6
Jumpers and connectors, 1-26, 2-5
Connector functions, 2-7
Jumper settings, 2-6
Locations, 2-5
L
Leaving setup, 3-49
Left panel, 1-6
Load setup default settings, 3-48
M
Main board ID, 3-9
Main board s/n, 3-9
Major components, 2-3
Memory configurations, 2-19
Memory parity mode, 3-7
Memory test, 3-19
Memory upgrade, 2-19
Configurations, 2-19
DIMM, installing, 2-20
DIMM, removing, 2-21
Reconfiguring the system, 2-21
Memory/cache configuration, 3-33
N
Num lock after boot, 3-19
O
Onboard devices configuration, 3-22
Onboard USB, 3-7, 3-28
Opening the housing panels, 1-5
Front panel, 1-2, 1-5