Acer ALTOS 1100E - Manual (Page 156)

Altos 1100E Series User’s Guide 2
Host adapter SCSI ID, 4-6
Host adapter SCSI termination, 4-9
Initiate sync negotiation, 4-12
Initiate wide negotiation, 4-14
Maximum sync transfer rate, 4-13
SCSI device configuration, 4-11
SCSI parity checking, 4-8
Send start unit command, 4-15
Configuring multiple SCSI
controllers, 4-21
Connector functions, 2-7
Correcting error conditions, 2-29
CPU speed configuration, 3-35
D
Date, 3-44
Date and time, 3-44
Date, 3-44
Time, 3-45
Device connected, but not ready, 4-
24
Disk drive configuration problems,
4-25
Booting the computer from a SCSI
drive, 4-26
Computer hangs, or SCSI
controller cannot always find the
drives, 4-28
Using a SCSI drive as C and
another SCSI drive as D, 4-27
Using a standard drive as C and a
SCSI drive as D, 4-26
Disk drive control, 3-40
Disk drives, 3-10
Floppy drives, 3-12
IDE drives, 3-12
E
Entering setup, 3-1
Error messages, 2-26
Correcting, 2-29
Software, 2-26
System, 2-26
ESD precautions, 2-11
External cache, 3-5
F
Fast POST mode, 3-18
Features, 1-2, 1-25, 2-1
Front panel, 1-2, 1-5
Rear panel, 1-3
Floppy drive A, 3-5
Floppy drive B, 3-5
Floppy drives, 3-12
Format disk, 4-20
Front panel, 1-2, 1-5
Front panel connectors, 2-9
H
Hard disk drive cage
Jumpers and connectors, 1-26
Host adapter SCSI ID, 4-6
Hot-swappable redundant power
supply module, installing and
removing, 1-21
I
IDE drives, 3-12
IDE primary channel master, 3-6
IDE primary channel slave, 3-6