Acer ALTOS 1100E - Manual (Page 129)

Chapter 4 – SCSISelect Configuration Utility 4-3
4.1.2 When to Use the SCSISelect Utility
Use the SCSISelect utility if you need to
• Change any of the default values listed in the settings table
• Check and/or change SCSI device settings that may conflict with those of
other devices (e.g., SCSI ID)
• Perform low-level formatting on new SCSI disk devices
4.1.3 Running the SCSISelect Utility
To start SCSISelect, press Ctrl+A when the following is displayed during power-up
or reset:
Press for SCSISelect

Utility!
This message appears after BIOS and POST information displays, and after the
banner listing the Adaptec AHA-3950U2B version number.