Acer ALTOS 1100E - Manual (Page 136)

Altos 1100E Series User’s Guide 4-10
Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero). We recommend that you not change this setting. Some
operating systems will not run unless the boot device is set at zero.
The figure below shows the Boot Device Options screen.
Arrow keys to move cursor, to select option, to exit ( =default)
Adaptec AHA-3950U2B SCSISelect (TM) Utility
AHA-3950U2B at Bus:Device 00:00h
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Low ON/High ON
Additional Options
Boot Device Options .................................. Press
SCSI Device Configuration ........................ Press
Advanced Configuration Options ............... Press
- Reset to Host Adapter Defaults
*
Select SCSI peripherals from which to boot
To view peripherals by ID# select “SCSI Disk Utilities” from previous menu
Boot Channel............................................................................... A First
Boot SCSI………………………………………………………………0
Boot Lun Number ........................................................................ 0
Boot Device Configuration
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled------------
Figure 4-7 Boot Device Options Screen