Acer ALTOS 1100E - Manual (Page 106)

Altos 1100E Series User’s Guide 3-30
PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI devices. If you
use plug-and-play (PnP) devices, set this parameter to Auto. The system then
automatically assigns IRQs to PnP devices. If your PCI device is not a PnP, you
can manually assign the interrupt for each device. Refer to your PCI card manual
for more information. The default setting is Auto.
When the PCI IRQ Setting is set to Auto, all
the IRQ setting fields become gray and non-
configurable.
PCI Slots
These parameters allow you to specify the appropriate interrupt for each of the PCI
devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11, IRQ12,
IRQ14, or IRQ15 to the slots.
Make sure that the interrupt you assign to the
various PCI slots are not used by other
devices to avoid conflicts.
Press or to move between fields. Press or to select options.
AGP
This item shows the assigned interrupt for the onboard accelerated graphics port
(AGP) controller.
Onboard LAN
This item allows you to manually assign the interrupt for the onboard LAN when
the PCI IRQ Setting parameter is set to Manual. This parameter is grayed and not
user-configurable when the PCI IRQ Setting is set to Auto.