Acer ALTOS 1100E - Manual (Page 132)

Altos 1100E Series User’s Guide 4-6
Arrow keys to move cursor, to select option, to exit ( =default)
Adaptec AHA-3950U2B SCSISelect (TM) Utility
AHA-3950U2B at Bus:Device 00:00h
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Automatic
Additional Options
Boot Device Options .................................. Press
SCSI Device Configuration ........................ Press
Advanced Configuration Options ............... Press
- Reset to Host Adapter Defaults
*
Figure 4-3 Configure/View Host Adapter Settings Screen (2 of 2)
Use the cursor ( ↑ ↓ ) to move to your selection. Press Enter to display a pop-up
menu of choices or to make selections. Press Esc at any time to return to the
previous menu.
Press F6 to reset all settings to the SCSI
controller defaults. SCSI controller default
settings are marked with an asterisk (*)
throughout the selection submenus.
Host Adapter SCSI ID
This option allows you to change the host controller SCSI ID. The figure below
shows the available IDs for use with the AHA-3950U2B. The default setting is
SCSI ID 7. (We recommend that you not change this setting.) Some operating
system software will not run unless the SCSI controller ID is set at ID 7.