Vaisala HMT120 - Manual (Page 46)

User's Guide _______________________________________________________________________
44 ___________________________________________________________________ M211244EN-B
Restore Saved Settings
Use the RESTORE command to restore saved settings from transmitter
FLASH memory to RAM. All unsaved changes will be lost.
RESTORE
Example:
>restore
Restoring default settings...done
>
Reset Transmitter
Use the RESET command to reset the transmitter. Upon reset or power-
up, the transmitter enters the serial mode that has been set with the
SMODE command.
After reset the configuration is loaded from FLASH memory. That
configuration can be altered with SAVE-command.
RESET
Example (transmitter set to serial mode STOP, will output transmitter
software version at reset):
>reset
HMT120 / 0.1.0.001
Type "help" for command list
>
Restore Factory Settings
Use the FRESTORE command to restore the factory settings to the
transmitter. All user settings, including the user-performed calibration
corrections, will be lost. The transmitter will revert back to the factory
calibrated settings. Note that this only returns the factory settings of the
transmitter and not of the interchangeable probe (see section Restore
Probe RH Factory Calibration on page 34 and section Restore Probe T
Factory Calibration on page 35).
FRESTORE
Example:
>frestore
Restoring factory defaults...done
>