Vaisala HMT120 - Manual (Page 38)

User's Guide _______________________________________________________________________
36 ___________________________________________________________________ M211244EN-B
Configuring Serial Line Operation
Set/Show Serial Line Settings
Use the SERI command to show or set the serial line settings. Use the
SAVE command after changing the settings to store them. The new
settings will be taken into use when the transmitter is reset or powered
up.
SERI [b p d s]
where
b = baud rate (9600, 19200, 38400, 76800, 115200)
p = parity (n = none, e = even, o = odd)
d = data bits (7 or 8)
s = stop bits (1 or 2)
Examples:
>seri
Baud P D S : 19200 N 8 1
>
>seri 9600 e 7 1
Baud rate : 9600
Parity : E
Data bits : 7
Stop bits : 1
>save
Saving settings...done
>
Set/Show Terminal Echo
To show or set the terminal echo status, use the ECHO command.
ECHO [ON/OFF]
Examples:
>echo
COM1 Echo : OFF
>
>echo on
COM1 Echo : ON
>