Vaisala HMT120 - Manual (Page 45)

Chapter 4 _______________________________________________________________ Service Port
VAISALA ________________________________________________________________________ 43
Display Command List
Use the HELP command to display a list of available commands.
HELP
Display Active Errors
Use the ERRS command to display the currently active error codes. For
troubleshooting active errors, see Table 7 on page 67.
ERRS
Example (no active errors):
>errs
No errors.
>
Save Changed Settings
Use the SAVE command to save changed settings to the transmitter
FLASH memory. Most settings have to be saved or the changes are lost
at the next reset or power down.
NOTE The SMODE command saves the new serial mode immediately;
a separate SAVE command is not needed.
The probe calibration commands (CRH, CT, CRHCLR, CTCLR) store
the parameters into the probe's memory automatically without a separate
SAVE command.
SAVE
Example:
>save
Saving settings...done
>