Atmel SpaceWire Router SpW-10X - Manual (Page 121)

Ref.: UoD_SpW-10X_
UserManual
Issue: 3.4
SpW-10X
SpaceWire Router
User Manual Date: 11 th
July 2008
Preliminary
121
Table 9-11 Error Active Register Fields
Bits Name Reset
Value Description Read/Write
0 Configuration Port
Error Active
‘0’ Indicates that the Error Active bit in the
configuration port is asserted.
A write to this register with bit 0 set will clear all
the error flags in the configuration port
control/status register.
R/W
30:1 SpaceWire and
External Port Error
Active
All bits
set to
zero Indicates that the Error Active bit in the
corresponding number SpaceWire or External
port is asserted.
A write to this register with one or more of
these bits set will clear all the error flags in the
corresponding SpaceWire and External port
control/status registers.
When writing to this register with all bits set all
error flags in all port control/status registers are
cleared.
Note: only bits 10:1 are used in the SpW-10X
router.
R/W
31 Not used All bits
set to
zero Not used because there are a maximum of 30
SpaceWire / External ports supported by the
router design. R
9.5.5 Time-Code Register
The time-code register address is 260 (0x0000 0104).
The time-code register contains the current value of the internal time-code register. Its fields are
shown in Figure 9-7 and described in Table 9-12.
Time value
31
Time-code flags
7 6 0
Not used
5 8
Figure 9-7 Time-Code Register Fields