AirSep MN131-1 B - Manual (Page 237)

FreeStyle™ EN
AirSep
®
Corporation EN-25
MN131-1 rev. B - 02/13
Use with DC Power (Automobile, Motorboat etc.)
Caution: When using FreeStyle with the universal power supply in an
automobile, boat, or other motor vehicle, make sure that the vehicle is started
and running before turning on and operating the FreeStyle unit. If the power
supply indicator light does not illuminate and requires resetting, disconnect the
power supply from the motor vehicle’s DC outlet, restart your vehicle, and then
reconnect your power supply into the DC outlet.
1. Make sure your power supply is securely connected to the FreeStyle inlet,
as shown in Figure 14.
2. Connect the proper DC power cord end to the inlet marked ACCESSORY
DC IN on the power supply, as shown in Figure 17.
3. Turn on your motor vehicle.
4. Connect the DC power cord to the motor vehicle’s DC outlet, as shown in
Figure 18.
5. To operate the POC, press the FreeStyle [1], [2], or [3] setting on the
unit’s top panel, as determined by your prescription. To turn the unit off,
press the setting associated with the LED illuminated above it.
Figure 17
Figure 18