AirSep MN131-1 B - Manual (Page 228)

EN FreeStyle™
EN-16 AirSep
®
Corporation
MN131-1 rev. B - 02/13
The FreeStyle battery does not need to be fully discharged before
recharging. It is recommended to charge the FreeStyle battery
after each use.
Charging may take several minutes after connecting the power to
initiate, depending on the battery’s internal operating temperature.
This is a normal condition and is intended for safe battery
charging. This circumstance is more likely when the battery has
been fully discharged.
Figure 7: Internal Battery Charging Figure 8: AirBelt Battery Charging
AirBelt does not need to be fully discharged before recharging. It is
recommended to charge it after each use.
• The FreeStyle’s internal battery will completely recharge from its fully
depleted state in approximately 3 ½ hours, whether or not the unit is in use
on Universal AC/DC power.
• While charging a fully discharged battery, initially the 25% LED will start
blinking rapidly for a few minutes, then start to blink at a slower rate every
(1/2 second).
• The LED will continue to blink until 25% capacity is reached. The LED will
then turn solid.
• Each of the four LEDs, 25% -100%, will blink as stated above, then turn solid
when they reach their capacity.
• When all LEDs illuminate solid, the battery is fully charged and the LEDs will
remain solid for a period of time, then all four LEDs will turn off.