AirSep MN083-1 - Manual

AirSep FreeStyle5 POC
Reading and Recording Hours
1.) Insert the USB to TTL Serial Converter Cable (MI347) into an open USB port on your PC.
3.) When the program
starts, you will see the
Focus/FreeStyle 5 Data
Interface box appear.
2.) Start the program by
clicking on the Focus-
FreeStyle 5 Data
Interface icon on your
desktop.
4.) Unscrew the three
screws on the front of the
FreeStyle 5 and remove the
front cover.
5.) Lay the FreeStyle 5
unit on its back, and
then connect the
other end of the data
cable to J11 on the
circuit board. The
black wire goes to the
left as shown.
Note: Communication is only possible when the FreeStyle 5 unit is in test mode.
To activate the unit’s test mode:
•
Turn the unit on in flow setting 4.
•
After the 10 second start up time, press flow settings 1 and 5 simultaneously for 3 seconds.
• All 5 flow setting LED’s will light after the 3 seconds. The unit will then start to auto pulse when in test mode.
•
If unit is not pulsing, turn unit off and repeat all steps.
6.) The Data Cable is now connecting the PC and the FreeStyle 5. Next plug the FreeStyle
5 unit into AC power, and then put the unit into test mode.
7.) When the FreeStyle 5 unit
enters Test Mode, the
Focus/FreeStyle 5 Data
Interface Program on your PC
will display hours in the Unit
Run Time box, and the
Compressor Run Time box
within 2 minutes.
Screws
8.) You may now record the hours from the Unit Run Time box. When recorded, turn
the FreeStyle 5 off, disconnect AC power, disconnect data cable, and re-assemble.
MN083-1 Rev -
Screw
Black wire
on left