Ag Leader GPS 3100 Operators Manual - Manual (Page 7)

Add-On GPS 3000/3050/3100 Installing Add-On GPS
Ag Leader Technology
June 2001 Rev. 1 3000124 5
Install Window
Mount PF3000
Bracket The window mount bracket for the Add-On GPS 3000/3050/3100, will
provide a very secure mounting for the PF3000 ONLY IF the window
glass surface is chemically cleaned. Some installers have reported
problems with the adhesive strips coming off the glass. This is a
problem only if the glass was not properly cleaned and dry. Follow
Steps 1 through 6 to ensure the glass is clean and dry for installation:
Step Action
1 In humid conditions where moisture may condense on the
glass, run the air conditioner on a medium to warm
temperature setting to fill the cab with dry air. Run air
conditioner until the glass is dry.
2 Determine the position for the window bracket on the
window.
3 Using a clean, unused paper towel, wipe off an area of the
window larger than where you have determined is proper
position for the bracket.
4 When the glass is visually clean, use one of the provided
alcohol swabs to wipe a slightly smaller area.
5 Before the alcohol dries, use a clean, unused paper towel
to wipe off the area.
6 Repeat Steps 4 and 5, so the glass has been cleaned twice
with alcohol swabs.
7 Carefully remove the peel-off strips from the adhesive
strips on the back of the PF3000. Do not touch the
adhesive surface of the strips.
8 IMPORTANT: Once the adhesive strip contacts the
glass the bracket cannot be moved without damage to
adhesive strips.
Without touching the strips to the glass, align the window
bracket with the position you determined in Step 2.
9 When bracket is properly aligned, push the bracket firmly
against the glass to bond the adhesive strips.
10 Use the heel of your hand or fist to gently pound on the
bracket to ensure that the adhesive is fully bonded to the
glass.
11 Attach PF 3000 to the bracket and attach 25-pin
connector.
NOTE: The adhesive strips cannot be re-installed if they
have pulled off the glass. Call Ag Leader Technology
(515-232-5363) if you need new adhesive.
***