Guidance, Guidance/steering control, Setup – Ag Leader Compass Manual User Manual

Page 83: Lightbar settings, Uidance, Teering, Ontrol, Etup, Ightbar, Ettings

UIDANCE

UIDANCE

TEERING

ONTROL

ETUP

Press: Home button > GPS button

• Manual Guidance
Select this to perform guidance by lightbar while manually
steering the vehicle.

• OnTrac2/OnTrac2+
For more information, see the OnTrac2 section.

• ParaDyme Steering
For more information, see the ParaDyme insert.

• Operator Presence Alarm

The Operator Presence Alarm disengages guidance control if the operator does not have any interaction
with the display for a specified period of time. Use the drop-down menu to specify the period of time before
guidance is automatically disengaged.

• Lightbar Settings
For more information, see

“Lightbar Settings” on page 75

• Required Differential Correction for Guidance
When un-checked allows guidance to operate without differential correction.

Pressing the Setup (wrench) button on the Guidance Tab opens the guidance system
settings for the selected guidance system.

Note: In order to use guidance with the display, you must have a GPS receiver capable of a GPS output rate
of 5 Hz or more.

IGHTBAR

ETTINGS

ETUP

Require Differential
Correction for Guidance

Steering

Manual Guidance

Operator Presence Alarm

15 Minutes

(Autodetect)

Receiver

GPS/Guidance Setup

Lightbar
Settings