Ag Leader InSight Direct Command Liquid - Manual (Page 8)

Part No. 2002831-38 Rev. B 8
Controller Settings (continued)
STEPS ACTION
1 e Use the drop-down menu to select the Control Valve Configuration that your
machine is using. For further description of these Control Valve Configuration
Options, see page 9.
Note: If you select a servo type configuration continue on to step 1f. If you select a
PWM type configuration then skip to step 2.
1 f Use the arrow buttons on the right hand side of the Valve Response 1 to change to
the appropriate setting from your kit’s installation instructions.
1 g Use the arrows on the right hand side of the Valve Response 2 to change to the
appropriate setting from your kit’s installation instructions.
1 h Press the Response Threshold button to enter the response threshold needed for
your control valve. The appropriate values are included in your kit’s installation
instructions.
Note: The higher the threshold value the slower the rate will change. By contrast,
the lower the value, the faster the rate will change.
2 Note: Only use Step 2 if you selected PWM 12-Volt or PWM Ground for your
control valve configuration in Step 1e.
2 a Select the PWM Frequency button to enter the appropriate frequency.
2 b Select the PWM Gain button to enter the appropriate value found for your PWM
valve.
Note: A larger gain value will cause the system to make more aggressive rate
changes, a lower value will slow the rate response. Press Accept.
2 c Select the Zero Flow Offset button to enter the appropriate setting shown in your
kit’s installation instructions. Press Accept.