Ag Leader InSight Direct Command Liquid - Manual (Page 7)

Part No. 2002831-38 Rev. B 7
Vehicle Settings (continued)
STEPS ACTION
3 a Select the Hitch tab.
3 b Select the keyboard button next to the Rear Draw Bar setting. Enter the
distance from the rear axle to the rear drawbar on the vehicle.
3 c Select the keyboard button next to the Rear 3-Point Hitch setting. Enter the
distance from the rear axle to the rear 3-point hitch on the vehicle
3 d Select the keyboard button next to the Front Draw Bar setting. Enter the
distance from the rear axle to the front drawbar on the vehicle.
3 e Select the keyboard button next to the Front 3-Point Hitch setting. Enter the
distance from the rear axle to the front 3-point hitch on the vehicle.
3 f When finished, press Exit and proceed to operation.
Section 6: Controller Settings
To adjust Controller Settings, first press the Controller Tab, then highlight the
DirectLiquid controller from the Controller List and press the Controller Settings
button. Follow the instructions below.
Controller Settings
STEPS ACTION
1 a Verify that the Flow Meter Calibration Number is correct.
1 b Press the Flow Control Delay button to enter a delay setting.
Note: This setting is a delay for the control valve to adjust after the flow is turned
on. Press Accept when finished.
1 c Close flow control valve when rate off. Check this setting if you have a control
system with no section valves. If you have an anhydrous heat exchanger that uses
the flow control valve to shutoff flow (does not have separate on/off valve) check
mark this setting. Not checking this setting leaves the flow control valve in its last
position when the section valves are shut off.
1 d Use the arrows on the right hand side of the Allowable Error setting to change the
setting. A 2% error setting is recommended. The InSight will stop adjusting the
control valve when the actual rate is within this percentage error of the target rate.