Ag Leader InSight Direct Command Liquid - Manual (Page 3)

Part No. 2002831-38 Rev. B 3
Application Configuration (continued)
STEPS ACTION
3 e Enter a controller name. A default name of DirectLiquid appears. If you would
like to change this name, press the keyboard button, enter a new name and press
Finish.
3 f The Operating Configuration Wizard reappears. Select a container from the
drop-down list, or press the New button to create a new container.
3 g The Container Setup Wizard appears. Enter a container capacity and units, then
press Next.
3 h Enter a container name and location. Press Finish.
4 The Operating Configuration Wizard reappears. Select a primary and backup
Ground Speed Source. In most cases GPS is the primary speed source with
Radar serving as backup. If you are using a backup radar speed source it is
recommended that you calibrate it before the season begins. When finished,
press Next.
Note: Ground Speed calibrations are completed under the Calibrate Distance
button on the Application Setup Configuration window.
5 a The Configuration name defaults to a name based on your previous
configuration settings. To edit the name, press the keyboard button and type a
new name.
5 b Press Finish to complete the wizard and to save the configuration into the
InSight display.