A notes on connecting external arrays, Connecting thunder 9500v subsystems, Notes on connecting external – HP StorageWorks XP Remote Web Console Software User Manual
Page 142: Arrays, Notes on connecting external arrays
A Notes on connecting external arrays
Connecting Thunder 9500V subsystems
System parameters for connecting Thunder 9500V subsystems
explains whether to specify system parameters when making settings for ports
on the Thunder 9500V subsystem.
Table 12 System parameter settings (Thunder 9500V subsystems)
Parameter setting
Parameter
Pane name
Start Attribute
System Startup Settings
Specify this parameter when the Thunder 9500V subsystem
is in the one-controller configuration.
•
Single Mode
Specify this parameter when the Thunder 9500V subsystem
is in the two-controller configuration.
NOTE:
Be sure to specify that Data Share Mode will be
used.
•
Dual Active Mode
Do not specify this parameter.
•
Hot Stand-By Mode
You can either specify this parameter or omit specifying this
parameter.
Delay Planned Shutdown
Common 1
You can either specify this parameter or omit specifying this
parameter.
SCSI Fibre Channel
Common Options
OPTION 1
You can either specify this parameter or omit specifying this
parameter.
SCSI Fibre Channel
Common Options
OPTION 2
Set this parameter to Reset of occurred.
Operation if the processor
failure occurs
Data Striping
Set this parameter to ON.
Command Queuing Mode
Inquiry Setting
Keep this parameter as HITACHI (default), and do not
change.
Vendor ID
Keep this parameter as DF600F (default), and do not
change.
Product ID
You can either specify this parameter or omit specifying this
parameter.
ROM Microprogram
Version
You can either specify this parameter or omit specifying this
parameter.
RAM Microprogram
Version
You can either specify this parameter or omit specifying this
parameter.
WEB Title
Reset/LIP Mode
Port Type
You can either specify this parameter or omit specifying this
parameter.
•
Reset/LIP Mode
(Signal)
You can either specify this parameter or omit specifying this
parameter.
•
Reset/LIP Mode
(Process)
You can either specify this parameter or omit specifying this
parameter.
•
LIP Reset Mode
You can either specify this parameter or omit specifying this
parameter.
RS232C Error Information
Outflow Mode
Controller Option
142
Notes on connecting external arrays