HP StorageWorks DAT 72x10 Tape Autoloader - Manual (Page 24)

Figure 8 Installing the rails into the rack (example shows an HP Rack10000 Series)
Description Number
1 Use the screws (x8) from the screw pack for your rack type.
To install the autoloader on the rails and into the rack:
1. Locate the captive screws on the front mounting brackets of the autoloader (see Figure 9 ).
2. Slide the back edge of the autoloader onto the rails. Push the autoloader back until the front bezel
is flush with the front rack columns.
NOTE:
There should be no cables connected to the autoloader at this point.
3. From the front of the autoloader, secure the front mounting brackets to the rack using a #2 Phillips
screw driver to tighten the captive screws on each side of the autoloader, as shown in Figure 9 .
24 Installing the autoloader