beautypg.com

HP XP RAID Manager Software User Manual

Page 52

background image

Table 21 RAID Manager error codes for SSB1: B901, B9A8, B9A9, B9AD, B9AE (continued)

Cause of Error

RAID Manager
Command

SSB2

Since quorum disks are specified as P-VOLs of Snapshot pairs, the command
ends abnormally.

paircreate, pairsplit,
pairresync, pairresync
-restore

9786

Since quorum disks are specified as S-VOLs of Snapshot pairs, the command
ends abnormally.

paircreate, pairsplit,
pairresync, pairresync
-restore

9787

Since one of the following cases occurred, the Snapshot pair cannot be created
by specifying the consistency number.

paircreate

978a

The specified consistency group number is in use for Business Copy.

The number of pairs has already exceeded the maximum number of pairs
that can be created for one consistency group.

The pair that uses the same P-VOL exists already in the specified consistency
group.

The Snapshot pair cannot be created because the specified consistency group
number is out of the range of the number that can be specified.

paircreate

978b

The Snapshot data cannot be stored because the Continuous Access Synchronous
asynchronous pair status is other than PSUS or PSUE when Snapshot (P-VOL)
and Continuous Access Synchronous asynchronous (S-VOL) share the volume.

pairsplit

978c

The Thin Provisioning virtual volume, which is undergoing capacity expansion,
is specified as the Snapshot P-VOL. Therefore, the Snapshot pair cannot be
created.

paircreate

9790

The Snapshot pair cannot be created because the Thin Provisioning V-VOL that
is discarding zero data is specified as a P-VOL of the Snapshot pair.

paircreate

9793

Since the volume without path definition is specified as a P-VOL of the Snapshot
pair, the command ends abnormally.

paircreate, pairsplit,
pairresync, pairresync
-restore

9796

Since the volume without path definition is specified as a S-VOL of the Snapshot
pair, the command ends abnormally.

paircreate, pairsplit,
pairresync, pairresync
-restore

9797

Already you made the maximum number of Snapshot pairs, no new Snapshot
pair can be created.

paircreate

97A1

The Snapshot pair operation failed because the specified S-VOL is wrong.

paircreate, pairsplit,
pairresync

B912

The consistency group information can not be obtained because the Snapshot
is not installed.

All commands

B9A7

52

Troubleshooting

This manual is related to the following products: