HP XP RAID Manager Software - Manual (Page 48)

Table 21 RAID Manager error codes for SSB1: B901, B9A8, B9A9, B9AD, B9AE (continued)
Cause of Error RAID Manager
Command SSB2
Since the capacity of the pair exceeds the licensed capacity, the pair cannot be
created. paircreate 9707
The command ended abnormally because the command other than the paircreate
command was issued for the volume in the pair other than the Snapshot pair. All commands 9718
This error also may be reported when the command is executed with specifying
an unsupported parameter.
The command ended abnormally because the pair is in the status that the
corresponding command is not accepted at present. All commands 9719
This error also may be reported when the command is executed with specifying
an unsupported parameter.
Since the capacity of shared memory is insufficient, the pair cannot be created. paircreate 971a
Since the attribute of the specified pool is other than Snapshot, Snapshot pair
cannot be created. paircreate 971b
Since the volume you specified as the P-VOL has an S-VOL Disable attribute,
Snapshot pair cannot be restored. pairresync -restore 971f
An operation error occured in Snapshot because of the following reasons.
•
The LDEV number that is specified for P-VOL or S-VOL is not correct.
• The specified P-VOL or S-VOL has not been paired.
•
The pair that is specified by P-VOL or S-VOL is not ready for the specified
operation.
• The specified Snapshot ID (MU number) is not correct.
•
The specified Snapshot ID (MU number) is already in use.
•
The specified pool is unusable.
• The license capacity is exceeded.
•
Control tables for Snapshot are running out.
All commands 9720
Since either Snapshot or Business Copy is not installed, the command ends
abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 9721
Because of no additional shared memory (FC Z, TPF, Extension1), the command
ends abnormally. All commands 9723
Because of no additional shared memory (more than COW1), the command
ends abnormally. All commands 9724
Since the LDEV number of the volume you specified as the P-VOL is beyond the
specified range, the command ends abnormally. All commands 9725
Since you specified the unmounted volume as the Snapshot P-VOL, the command
ends abnormally. All commands 9726
Since you specified the blocked volume as the Snapshot P-VOL, the command
ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 9727
Since you specified the volume that is in process of formatting as the Snapshot
P-VOL, the command ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 9728
Since you specified the volume whose emulation type is other than OPEN-V as
the Snapshot P-VOL, the command ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 9729
48 Troubleshooting