HP XP RAID Manager Software - Manual (Page 49)

Table 21 RAID Manager error codes for SSB1: B901, B9A8, B9A9, B9AD, B9AE (continued)
Cause of Error RAID Manager
Command SSB2
Since the volume you specified as the Snapshot P-VOL has the command device
setting, the pair cannot be created. paircreate 972a
Since the capacity of the volume you specified as the Snapshot P-VOL exceeds
the supported size (4TB), the pair cannot be created. paircreate 972c
Since the capacity of the volume you specified as the Snapshot S-VOL exceeds
the supported size (4TB), the pair cannot be created. paircreate 972e
Since you specified a V-VOL as the Snapshot P-VOL, the pair cannot be created. paircreate 972f
Since you specified a pool-VOL as the Snapshot P-VOL, the pair cannot be
created. paircreate 9730
When Snapshot P-VOL and Continuous Access Synchronous P-VOL share the
volume, the status of the Continuous Access Synchronous pair is other than PSUS
or PSUE. Therefore, the Snapshot pair cannot be restored. pairresync -restore 9731
When Snapshot P-VOL and Continuous Access Journal P-VOL share the volume,
the status of the Continuous Access Journal pair is other than PSUS or PSUE.
Therefore, the Snapshot pair cannot be restored. pairresync -restore 9732
Since Snapshot P-VOL and Continuous Access Synchronous S-VOL share the
volume, the Snapshot pair cannot be restored. pairresync -restore 9733
Since Snapshot P-VOL and Continuous Access Journal S-VOL share the volume,
the Snapshot pair cannot be restored. pairresync -restore 9734
Since you specified Continuous Access Journal’s journal volume as the Snapshot
P-VOL, the pair cannot be created. paircreate 9735
Since the LUSE volumes you specified for the P-VOL and S-VOL do not have the
same structure, the command ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 9736
Since you specified the volume with the VMA setting as the Snapshot P-VOL, the
pair cannot be created. paircreate 973a
Since the LDEV number of the volume you specified as the S-VOL is beyond the
specified range, the command ends abnormally. All commands 973b
Since you specified the unmounted volume as the Snapshot S-VOL, the command
ends abnormally. All commands 973c
Since you specified the blocked volume as the Snapshot S-VOL, the command
ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 973d
Since you specified the volume that is in process of formatting as the Snapshot
S-VOL, the command ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 973e
Since you specified the volume whose emulation type is other than OPEN-V as
the Snapshot S-VOL, the command ends abnormally. paircreate, pairsplit,
pairresync, pairresync
-restore 973f
Since the volume you specified as the Snapshot S-VOL has the command device
setting, the pair cannot be created. paircreate 9740
Since you specified an external volume as the Snapshot S-VOL, the pair cannot
be created. paircreate 9742
Since you specified the volume other than V-VOLs as the Snapshot S-VOL, the
pair cannot be created. paircreate 9745
Since you specified a pool-VOL as the Snapshot S-VOL, the pair cannot be
created. paircreate 9746
Troubleshooting with RAID Manager 49