HP Multi-Site Traffic Director sa9200 - Manual (Page 93)

C H A P T E R 6 Global & CLI System Commands
87
more Pauses the screen after displaying a full screen until the
key is pressed. See the section entitled Pipes earlier in this
Chapter.
netstat Displays the SA9200’s routing tables.
nslookup Performs an nslookup of the specified IP address or hostname
Syntax::
nslookup
where:
•
ipaddr is the IP address
•
standard 8.5 X 11" is the name of the host
ping Tests the network connection to another networking device. It
sends an ICMP packet from the SA9200 to the target device;
when it receives the packet, it sends a ping reply. When the
SA9200 receives the reply, it displays a message indicating that
the specified IP address is alive. If the unit receives no reply, it
displays a message indicating that the target device is not
responding.
Syntax:
ping
where:
ipaddress is the IP address of the other networking device.
hostname is the host name of the other networking device.
quit Exits the current session.
reboot Reboots the SA9200.
revert Returns the configuration to the last committed configuration.
start-wizard Starts the Quick Start Wizard, which is an automated, interactive
system configuration tool.
top Changes the prompt level to the system top or box level.
toplevel (also box) Changes the prompt level to the system top or box level.
Command Description
Global & CLI System Commands