HP Multi-Site Traffic Director sa9200 - Manual (Page 104)

C H A P T E R 6 HP Multi-Site Traffic Director Server Appliance SA9200 User Guide
98
config sys secondary
NOTE: The secondary
commands do not need to
be committed to become
active (they are in effect for
any future connection
attempts).
Changes the prompt level to the config sys secondary
branch.
info Displays information about which secondary SA9200s can
connect.
any Allows any secondary SA9200 to connect to the primary SA9200.
This command is executed on the primary SA9200.
flash Allows only secondary SA9200s with an IP address in the Flash
peer list to connect. This command is executed on the primary
SA9200.
list Displays only secondary SA9200s configured using the config
sys secondary create command.
create Adds addresses to the config sys secondary list. These are
addresses of SA9200s that can be connected as secondaries.
delete
NOTE: Deleting an
address prevents future
connections for the
specified address.
Deletes addresses from the config sys secondary list.
config sys ssh Changes the prompt level to the config sys ssh branch.
info Displays the current status of SSH enable or disable. If the status
was just changed, it reflects the changed status that is pending for
the reboot.
enable Enables SSH connections the next time the box is rebooted.
disable Disables SSH connections the next time the box is rebooted.
Command Description
Config Sys Commands