HP Multi-Site Traffic Director sa9200 - Manual (Page 169)

C H A P T E R 8 Rebooting with the New Image and Verifying Installation
163
Rebooting with the New Image
and Verifying Installation
NOTE: If any errors
occurred during
installation,
show sys
software info may
display the image as
installed, however it is
not safe to use. Use
config sys
software delete
to
delete the image and
repeat the installation
before continuing. If the
problem persists, contact
HP Technical Support.
When the image has been downloaded and installed, it can be verified
by typing
show sys software info . For example, after
downloading and installing an update , show sys software
info may display the following:
This indicates that the image at index 1 has been installed and is ready
for service, and the image at index 2 is running. To activate the new
image, type
config sys software boot 1 . The SA9200
reboots under the new image. This command can also be used to
revert to the previous version.
Restoring Your Previous
Configuration
After the SA9200 reboots and comes up under the new image, you
can restore your previous configuration with the
restore
command.
Index Product Version Patch Build
1 SA9200 3.0 1.0 D1
2 SA9200 3.1 0.0 D12 (running)