HP Designjet Z6200 Photo Printer - Manual (Page 75)

5. Insert all of the other printheads that need to be installed, and close the carriage cover.
6. Make sure that the end of the blue handle catches the wire loop on the near side of the carriage.
7. Lower the handle to rest on the carriage cover.
When all of the printheads have been inserted correctly and the printer has accepted them, the
printer beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message
appears on the front-panel display, you might need to reinsert the printhead.
8. Close the printer window.
9. The front-panel display confirms that all of the printheads are correctly inserted. The printer starts
checking and preparing the printheads. The default routine process, when all printheads are
ENWW Work with ink system components 67
Ha
nd
le
the
ink sys
tem