HP Designjet Z6200 Photo Printer User Manual

Page 48

Press the

key on the front panel, and then select a winding direction.

The printer advances the paper. Make sure that the paper passes in front of the loading table, as

shown.

Pull the paper taut to the position shown in the following figure. Do not attempt to pull more paper

out of the printer. Use tape to secure the paper to the spindle core. You might need to use more

tape than is shown in the following image. The paper should be secure enough to support the

weight of the loop-shaping core, which you insert in step 12.

NOTE:

If you are loading the take-up reel during printing you do not need to pull the paper taut.

Tape the paper to the spindle core when an adequate length of paper has fed from the printer

after printing begins.

NOTE:

To avoid having the paper skew as it winds onto the spindle core, make sure the paper

is straight when you attach it. It is sometimes useful to use the core grooves to align the paper.

Chapter 4 Handle the paper

ENWW

ndle the paper