HP Designjet Z6200 Photo Printer - Manual (Page 20)

The printer has three levels of power consumption.
● Plugged in: the power cord is plugged into the back of the printer
● Switched on: the switch at the back of the printer is in the on position
● Powered on: the Power key on the front panel shows a green light
If you wish to turn the printer on or off or reset the printer, the normal and recommended method is to
use the Power key on the front panel.
However, if you plan to store the printer indefinitely, you are recommended to power it off using the
Power key, and then also switch off the power switch at the rear. Also, if the Power key does not seem
to work, you can use the switch at the rear instead.
To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about three minutes to initialize and check and prepare
the printheads. Preparing the printheads takes about one minute and 15 seconds. However, if the
printer has been off for six weeks or more, preparing the printheads could take up to 45 minutes.
12 Chapter 1 Introduction ENWW
In
tr
od
u
ctio
n