HP Designjet Z6200 Photo Printer - Manual (Page 202)

Job management options Enable queue [E]
When to start printing [E]
Nest options Enable nesting [E]
Select wait time
Enable crop lines [E]
Oversize nested job margin
Autorotate
Max. number of printed jobs [E]
Select job recovery mode
Paper mismatch action
Front panel options Select language
Select display contrast
Enable buzzer
Select units [E]
Date and time options View current device time [E]
Set date [E]
Set time [E]
Set time zone [E]
Enable sleep mode
Sleep mode wait time
Resets Reset encoder cleaning
Restore factory settings
External hard disk Install (or Uninstall) external hard disk
Accessories Duplexer Install duplexer
Other accessories Install other accessories
Enable crop lines appears in two places in the menu: under Paper options (which applies to
individual jobs) and under Nest options (which applies to nested jobs). The default value is Off in
both cases.
Select palette allows you to choose between Software, Palette A, Palette B and Factory.
Define palette allows you to define the Palette A, Palette B and Factory palettes. To do so, select one
of the pens, between 0 and 15, after which you can change the width or color of the pen. The width
can vary from 0.13 mm (0.0051 in) to 12.0 mm (0.47 in) and the color can vary from 0 to 255.
Manual drying time allows you to choose a drying time from 1 to 1800 s. The default value is 100
s.
Enable nesting allows you to choose between Off, In order and Optimized order. In order to enable
nesting, When to start printing has to be set to After processing.
194 Appendix C Front-panel menus ENWW
Fron
t-panel
men
us