Error messages, Enww 201 – HP Designjet Z6200 Photo Printer User Manual
Page 209
Table D-2
Numeric error messages (continued)
Error code
Recommendation
61:01
Unsupported file format: the printer cannot process the job. Try the following remedies:
●
Turn off the printer by using the
Power
key on the front panel and the power switch at the
back of the printer; disconnect the power cord; then reconnect the power cord and turn
on the printer.
●
Make sure that the graphic language setting is correct. See
●
Resubmit the file to the printer.
●
Check that your printer firmware is up to date. See
If the problem persists, contact HP Support. See
61:04.1
The PostScript fonts are missing. Install the latest firmware release to reinstall the fonts. See
Update the printer firmware on page 138
.
61:04.2
Unrecognized paper type identifier. Install the latest firmware release to reinstall the paper
type identifiers. See
Update the printer firmware on page 138
.
61:08
The paper type has changed. Please resubmit the job.
61:08.1
The file cannot be printed because it is password-protected. Please resubmit the job without
password protection.
61:08.2
The job contains format errors or incorrect setting values. Please resubmit the job.
63:04
An input/output problem has occurred with the network card. Try the following remedies:
●
Make sure that the network cable is correctly connected to the network card.
●
Check that your printer firmware is up to date. See
If the problem persists, contact HP Support. See
71:03
An “out of memory” failure has occurred. Turn off the printer by using the
Power
key on the
front panel and the power switch at the back of the printer; disconnect the power cord; then
reconnect the power cord and turn on the printer.
71:08
Insufficient display list memory. Please resubmit the job with one or more of the following
changes: reduce resolution to 300 dpi, select Econofast print mode, select ‘Send Job As
Bitmap’ to have the main processing of the print job done by the computer rather than by the
printer.
74:01
An error occurred when uploading the firmware update file. Try the following remedies:
●
Turn off the printer by using the
Power
key on the front panel and the power switch at the
back of the printer; disconnect the power cord; then reconnect the power cord and turn
on the printer.
●
Try again to upload the firmware update file to the printer. See
.
If the problem persists, contact HP Support. See
76:03
The hard disk is full. Use the Embedded Web Server to remove unnecessary files from the
printer's hard disk.
If the problem persists, contact HP Support. See
ENWW
201
Error messages