HP LaserJet Enterprise 500 Color MFP M575 - Manual (Page 54)

Print envelopes
If your software does not automatically format an envelope, specify Landscape for page orientation in
your software program or print driver. Use the following guidelines to set margins for return and
destination addresses on Commercial #10 or DL envelopes:
Address type Left margin Top margin
Return 15 mm (0.6 in) 15 mm (0.6 in)
Destination 102 mm (4 in) 51 mm (2 in)
For envelopes of other sizes, adjust the margin settings accordingly.
Automatic paper sensing (auto-sense mode)
The automatic paper type sensor functions when a tray is configured to the Any Type or Plain setting.
After it has picked up paper from the tray, the product can detect overhead transparencies, paper
weight, and gloss level.
For more control, select a specific paper type for the job or configure the tray for a specific paper type.
Auto-sense settings
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
● General Settings
● Print Quality
● Auto Sense Behavior
3. Select one of the auto-sense modes.
Full sensing (Tray 1 only) For each sheet of paper that it picks up from the tray, the product detects light
paper, plain paper, heavy paper, glossy paper, tough paper, and transparencies.
Expanded sensing
NOTE: This is the default setting for all
trays.
For the first few sheets of paper that it picks up from the tray, the product detects
light paper, plain paper, heavy paper, glossy paper, tough paper, and
transparencies. The product assumes the rest of the pages are of the same type.
Transparency Only The product distinguishes between transparencies and non-transparencies. This
setting provides the fastest printing, but for some paper types it might reduce print
quality.
38 Chapter 3 Input trays and output bins ENWW