HP Prime Graphing Calculator - Manual (Page 533)

Programming in HP PPL 527
2. Press V to see the
custom app menu.
Here you can reset
the app (Start), set
the number of sides
of the dice, the
number of rolls, and
execute a simulation.
3. Select Set Rolls and enter 100.
4. Select Set Sides and enter 6.
5. Select Roll Dice.
You will see a
histogram similar to
the own shown in
the figure.
6. Press M to see the
data and P to
return to the
histogram.
7. To run another simulation, press V and select
Roll Dice.
Program commands
This section describes each program command. The
commands under the
menu are described first. The
commands under the menu are described in
“Commands under the Cmds menu” on page 534.