HP XP P9500 Storage - Manual (Page 91)

4
.
Restart the system.
# shutdown -Fr
5
.
Execute the following command to confirm that the kernel mode has been
changed properly.
# bootinfo -K
Set Up Cluster Software
To use HDLM in a cluster configuration, you need to perform the following
setup for the cluster software.
To set up cluster software:
1
.
Install the cluster software on all of the hosts in the cluster.
For details on the installation, see the documentation of the
corresponding cluster software.
2
.
Stop the cluster software services.
For details on how to stop the services, see the documentation of the
corresponding cluster software.
Performing a New Installation of HDLM
When Installing HDLM in a Local Boot Disk Environment
To perform a new installation of HDLM:
1
.
Log in to AIX as the root user.
If you are using a virtual I/O server, see the virtual I/O server
documentation to log in to AIX.
2
.
If there is no directory for mounting the DVD-ROM, make the directory.
# mkdir /cdrom
cdrom is the desired directory name. Hereafter, cdrom is used for
purposes of explanation.
3
.
Mount the DVD-ROM.
# mount -r -v cdrfs /dev/cd0 /cdrom
The /dev/cd0 part depends on the system.
4
.
Execute the following command to check that the devices to be managed
by HDLM have been recognized by the system:
# lsdev -Cc disk
hdisk0 Available 1S-08-00-8,0 16 Bit LVD SCSI Disk Drive
hdisk1 Available 1S-08-00-9,0 16 Bit LVD SCSI Disk Drive
hdisk2 Available 1S-08-00-10,0 16 Bit LVD SCSI Disk Drive
hdisk3 Available 1H-08-02 Hitachi Disk Array (Fibre)
hdisk4 Available 1H-08-02 Hitachi Disk Array (Fibre)
...
Creating an HDLM Environment
3-25
Hitachi Dynamic Link Manager User Guide for AIX ®