HP XP P9500 Storage - Manual (Page 225)

between these two parameter values. For details about the view
operation, see view (Displays Information) on page 6-33 . The HBA-
adapter-number.bus-number and adapter-type.adapter-number strings
are case-sensitive.
Example
The following example shows how to place online all paths connected
to an HBA port whose HBA adapter number is 01 and bus number is
01.
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /usr/DynamicLinkManager/bin/dlnkmgr online -hba 01.01
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-hbaid HBA-port-ID
Use this parameter to place online, at one time, all paths that pass
through a specific HBA port. The command will place online all paths
connected to the HBA port that has the specified HBA-port-ID. To display
the HBA port IDs, execute the following view operation:
# /usr/DynamicLinkManager/bin/dlnkmgr view -hba
For details about how to execute the view operation to display the HBA
port IDs, see To Display HBA Port Information on page 6-64 in
Parameters on page 6-35 .
Example
The following example shows how to place online all paths connected
to the HBA port whose HBA-port-ID is 00001.
# /usr/DynamicLinkManager/bin/dlnkmgr online -hbaid 00001
KAPL01104-I All the paths which pass the specified HBA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 15 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-cha -pathid AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass
through a specific CHA port. The command will place online all the paths
that pass through the CHA port to which the path with the specified
AutoPATH_ID is connected.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see view
(Displays Information) on page 6-33 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
Command Reference
6-13
Hitachi Dynamic Link Manager User Guide for AIX ®