HP XP P9500 Storage - Manual (Page 324)

Key name #1 Description #2
Necessity of
definition
Maxim
um
numbe
r of
charac
ters
New
installa
tion
Upgrad
e
installa
tion or
re-
installa
tion
off: Disabled
auto_failback_inte
rval Specify the interval in minutes from
the time the previous path status
check finished until the time the
next path status check started.
You can specify a check interval
from 1 to 1440. The default is 60.
Optional Optional 4
intermittent_error
_monitor
#3, #4
Specify one of the following values
to indicate whether to enable or
disable intermittent error
monitoring:
on: Enabled
off: Disabled (default)
Optional Optional 3
intermittent_error
_monitor_interval
#
4
Specify the interval in minutes that
monitoring for intermittent errors is
performed.
You can specify a check interval
from 1 to 1440. The default is 210.
Optional Optional 4
intermittent_error
_monitor_number
#4
Specify the number of times an
error (that is assumed to be an
intermittent error) occurs. You can
specify a value from 1 to 99. The
default is 3.
Optional Optional 2
dynamic_io_path_co
ntrol Specify whether to enable or
disable the dynamic I/O path
control function by using the values
below. Note that, if this function is
set, the setting for each storage
system or LU is cleared.
on: Enabled
off: Disabled (default)
Optional Optional 3
dynamic_io_path_co
ntrol_interval For the dynamic I/O path control
function, specify the checking
interval (in minutes) for reviewing
the information about the switching
of controllers performed by the
storage system.
#5
You can set the checking interval
from 1 to 1440. The default is 10.
Optional Optional 4
7-40
Utility Reference
Hitachi Dynamic Link Manager User Guide for AIX ®